Alfred's Serif Users' Forums — Current Page

Re: Current Page

null@example.com (Alfred) — Sat, 30 Mar 2024 12:47:09 +0000

Bobbus wrote:

Sometimes, a trial print in Draft mode helps check the orientation is correct for both sides etc.

Alternatively, publish as PDF. Then you’ll be able to check it in your favourite PDF viewer instead of wasting expensive ink/toner and paper.

Re: Current Page

null@example.com (Bobbus) — Sat, 30 Mar 2024 10:51:52 +0000

Hello.

When I use either Pageplus (9) or Drawplus (8) I consider my page (one) as: Front - right hand side, and Rear - Left side of the page (when folded).
A second or subsequent pages are constructed in the same way.
Sometimes I draw a thin dividing line down the centre to help when folding.

You should find then that your work prints as you want , - "current page" in each case.
Sometimes, a trial print in Draft mode helps check the orientation is correct for both sides etc.

I hope that helps.

Re: Current Page

null@example.com (GB) — Thu, 07 Dec 2023 23:35:52 +0000

Maybe just do the inside and outside as different files?

Current Page

null@example.com (TonyL) — Thu, 07 Dec 2023 12:41:43 +0000

I've been using Drawplus X8 for a number of years and I haven't found a way to get over this problem.
I mainly use the program for printing greetings cards (inside and outside), therefore, I only want to print the Current Page and not the Entire Drawing.
So far I haven't found a way of defaulting the print Range to Current Page. I have changed the Range to Current Page and saved the print Profile under a new name but when I then load this new profile the Range stays at the default of Entire Drawing.

I can't find a setting in the Registry either that might be overiding the profile.

Any suggestions please?