An independent forum site for members of the Serif software community
You are not logged in. Please login or register.
Automated signup has been disabled for these forums. If you wish to register, please send an email to admin[at]punster[dot]me stating your preferred username.
Embedded images: Click on the 
Add image to post link below the message box. Your photo will be uploaded to the postimage website and then shared here via a thumbnail link. Click on the thumbnail for a larger view.
Private messages: There is no pop-up alert for new PMs on these forums, so you need to look out for the PM link (near the top right-hand corner of any forum page) becoming bold.
Alfred's Serif Users' Forums → PagePlus → Drawing a precise circle
Hi All, I'm looking for a little help using PagePlus X8
I'm designing a record label. My circular record label needs to be exactly 91mm in diameter.
Is there a way of selecting a circle and entering a specific diameter value somewhere, to resize the circle?
If not, what is the best way to create an exact sized circle?
Start PPlus, go to Quick Ellipse and holding down the shift key draw it out to make a circle inside the page. Go to Transform and make sure that the measurement is what you want and linked, you can set it to the proper measurement then.
John
Hi John,
I just followed your advise, and it works perfectly.
Thanks for your help
Jason
Alfred's Serif Users' Forums → PagePlus → Drawing a precise circle
Powered by PunBB, supported by Informer Technologies, Inc.